Cisco 640-722 New & Updated Exam Questions

QUESTION 16

A client is attached to the Cisco Unified Wireless Network using controllers. When the client is using WPA2 and EAP authentication, where are the wireless encryption keys located during the active user session? (Choose two.)

A. on the access point
B. on the RADIUS server
C. on the Cisco WCS
D. on the client
E. on the Cisco WLC

Correct Answer: A, D

Cisco 640-722 Dumps Question Answers

QUESTION 15
When Cisco AnyConnect modules are installed on a PC, which module must be installed first?

A.  telemetry
B.  web security
C.  VPN
D.  NAM
E.  DART
F.  posture
G.  CSSC

Correct Answer: C

Cisco 640-722 Exam Questions

Question 14

You are about to use a hotel's guest wireless services using a wireless laptop. Which three items do you need to establish a wireless connection? (Choose three.)

A.  SSID name
B.  RF channel
C.  RF signal
D.  802.1X/EAP credentials
E.  pre-shared key
F.  web page
G.  WPA/WPA2 settings

Correct Answer: ACF

Cisco 640-722 Exam Questions

Question 13

The wireless network is using controller-based APs and version 7.0 MR1. The APs appear to be connected properly to the controllers. A wireless user near one of the APs reports that they are unable to connect to the network with their pre-shared key.

Which option shows the GUI path where you can check the connection status of that client?

A. WLANs > WLAN_ID > Advanced
B. Security > Clients
C. Security > Advanced > Clients
D. Monitor > Clients
E. Wireless > 802.11b/g/n > clients

Correct Answer: D

Cisco 640-722 Exam Study Material

Cisco 640-722 Question 12

Which two Cisco Unified Wireless Network capabilities use information that is provided by Radio Resource Management neighbor messages in version 7.0 MR1? (Choose two.)

A.  aggressive load balancing
B.  dynamic channel assignment
C.  hybrid remote edge access point
D.  inter-controller mobility (that is, mobility groups)
E.  rogue AP classification

Correct Answer: B,E 

Latests 640-722 Dumps Questions

Cisco 640-722 Question 11


Which two statements best describe the LAG configuration between a Cisco WLC and a Cisco Catalyst switch? (Choose two.)


A.  The Catalyst switch should be configured for PAgP.
B.  The Catalyst switch should be configured only for Layer 2 load balancing.
C.  The Catalyst switch should be configured for "on" mode.
D.  The Cisco WLC relies on the connected switch to perform the load-balance of traffic.
E.  The Cisco WLC aggregates multiple management interfaces into a single virtual interface.


Correct Answer: C,D

Cisco 640-722 Dumps Question Answers

QUESTION 10

Which two statements about the requirements to configure inter-controller roaming are true? (Choose two.)

A.  The same mobility domain names are configured across controllers.
B.  The same RF group names are configured across controllers.
C.  The same controller hardware version is configured across controllers.
D.  The same AP manager interface is configured across controllers.
E.  The same virtual interface is configured across controllers.
F.  The same controller software version is configured across controllers.

Correct Answer: A,E